When To Replace The Exhaust Filter; Replacing The Exhaust Filter; Replacing The Thread Lifters - Miele Boost CX1 PowerLine Operating Instructions Manual

en

When to replace the exhaust filter

Depending on the model, your vacuum
cleaner will be fitted as standard with
one of the following exhaust filters:
- Hygiene AirClean SF-HY 60 (tur-
quoise)
Replace this exhaust filter after ap-
prox. one year. Make a note of the
date on the exhaust filter.
- HEPA AirClean SF-HA 60 (white)
Replace this exhaust filter if the
timestrip® filter change indicator is
completely red.
The display will be completely filled
with red after approximately 50 oper-
ating hours; this corresponds to ap-
proximately one year of average use.
You can continue vacuuming when
the light comes on. However, the
suction power will be reduced as will
the effectiveness of the filter if it is
not replaced in good time.

Replacing the exhaust filter

(Fig. 42 + 43)
 Press the release catch on the ex-
haust filter compartment flap and re-
move the flap (Fig. 07).
 Pull the exhaust filter removal tab up-
wards and pull the exhaust filter for-
wards to remove it (Fig. 42).
 Place the insertion aids that are loc-
ated on both sides of the new ex-
haust filter into the guides on the ex-
haust filter compartment (Fig. 43).
 Push the exhaust filter back and up.
 Press the exhaust filter firmly into po-
sition until it clicks into place.
42
 If you have fitted your vacuum
cleaner with a HEPA AirClean exhaust
filter, press the timestrip® filter
change indicator (Fig. 09).
After approx. 10–15 seconds, a thin red
line will appear in the left-hand side of
the display (Fig. 10).
 Fit the exhaust filter compartment
flap carefully in the bottom of the ex-
haust filter compartment and close
the flap, making sure it clicks into po-
sition (Fig. 11).
Replacing the thread lifters (Fig. 44)
(not possible on models with Eco-
TeQ Plus floorhead)
The thread lifters on the suction inlet to
the floorhead can be replaced. Replace
the thread lifters if the pile has worn
down.
 Lever the thread lifters from the slots.
To do so use a suitable tool, e.g. a flat
blade screwdriver.
 Fit new thread lifters.
Replacement parts are available from
your Miele dealer or from the Miele
Spare Parts Dept.