When To Replace The Exhaust Filter; How To Replace The Airclean Filter; Replacing The Active Airclean 50 And Hepa Airclean 50 Exhaust Filters - Miele SDAE4 Operating Instructions Manual

Canister vacuum cleaner
Table of Contents

Advertisement

Available languages

Available languages

 Fit the filter bag into the holder as far
as it will go.
 Close the dust compartment lid se-
curely, making sure it clicks into posi-
tion. Take care not to trap the filter
bag when doing so.

When to replace the exhaust filter

Depending on the model, your vacuum
cleaner will come with one of the fol-
lowing exhaust filters (Fig. 08) as stan-
dard:
a AirClean
Replace this filter every time you start a
new packet of Miele FilterBags. An Air-
Clean exhaust filter is supplied with ev-
ery packet of Miele FilterBags.
b Active AirClean 50 (black)
c HEPA AirClean 50 (white)
Replace if the display for the exhaust fil-
ter change indicator is completely filled
with red (Fig. 13). This occurs after ap-
prox. 50 hours of operation which is
equivalent to about a year of average
use. The vacuum cleaner can still be
used.
However, the suction power will be re-
duced as will the effectiveness of the fil-
ter if it is not replaced in good time.

How to replace the AirClean filter

(Fig. 32 + 33)
Do not use more than one exhaust fil-
ter at a time.
 Open the dust compartment lid.
 Press the release catch on the filter
grille and open the grille until it clicks.
 Grasp the used AirClean exhaust filter
by one of the clean, unsoiled sections
and take it out.
 Replace it with a new AirClean ex-
haust filter.
If you wish to fit an Active AirClean
50 or HEPA AirClean 50 exhaust fil-
ter, see "Replacing one type of ex-
haust filter with another."
 Close the filter frame.
 Close the dust compartment lid.
Replacing the Active AirClean 50 and
HEPA AirClean 50 exhaust filters
(Fig. 34 + 35)
Do not use more than one exhaust fil-
ter at a time.
 Open the dust compartment lid.
 Lift the exhaust filter and remove it.
 Insert a new exhaust filter, making
sure it goes in properly, then push it
down into position.
 Press the TimeStrip® exhaust filter
change indicator (Fig. 11).
After approx. 10 –15 seconds a thin red
line will appear in the left-hand side of
the display (Fig. 12).
If you wish to fit the AirClean exhaust
filter, see "Replacing one type of ex-
haust filter with another".
 Close the dust compartment lid.
en-US
21

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sdbe0Sdce0Sdae0Sdbe4Sdce4

Table of Contents