Zanussi ZYNN9EW0 User Manual page 14

Problem
Water flows inside the refriger-
ator.
Water flows on the floor.
Temperature cannot be set.
The temperature in the appli-
ance is too low/too high.
If the advice does not lead to the
desired result, call the nearest
Authorized Service Centre.
CLOSING THE DOOR
1. Clean the door gaskets.
14
Possible cause
Appliance is fully loaded and is
set to the lowest temperature.
Temperature set in the appli-
ance is too low and the ambi-
ent temperature is too high.
Food products prevent the wa-
ter from flowing into the water
collector.
The water outlet is clogged.
The melting water outlet is not
connected to the evaporative
tray above the compressor.
The Super Freeze function is
switched on.
The temperature is not set cor-
rectly.
The door is not closed correct-
ly.
The food products' tempera-
ture is too high.
Many food products are stored
at the same time.
The door has been opened of-
ten.
The Super Freeze function is
switched on.
There is no cold air circulation
in the appliance.
2. If necessary, adjust the door. Refer to
"Installation" chapter.
3. If necessary, replace the defective door
gaskets. Contact the Authorised Service
Centre.
Solution
Set a higher temperature. Re-
fer to "Operation" chapter.
Set a higher temperature. Re-
fer to "Operation" chapter.
Make sure that food products
do not touch the rear plate.
Clean the water outlet.
Attach the melting water outlet
to the evaporative tray.
Switch off Super Freeze func-
tion manually, or wait until the
function deactivates automati-
cally to set the temperature.
Refer to "Super Freeze func-
tion" section.
Set a higher/lower tempera-
ture.
Refer to "Closing the door"
section.
Let the food products temper-
ature decrease to room tem-
perature before storage.
Store less food products at the
same time.
Open the door only if necessa-
ry.
Refer to "Super Freeze func-
tion" section.
Make sure that there is cold air
circulation in the appliance.
Refer to "Hints and Tips" chap-
ter.