Table of Contents
Advertisement
INSTALL COMPONENTS TO PC BOARD
Start Here
C2 - 1000µF 35V Lytic
C4 - 1000µF 35V Lytic
(see Figure J)
C1 - 1,000µF 35V Lytic
C5 - 1,000µF 35V Lytic
(see Figure J)
Figure J
These lytics must be mounted
horizontal to the PC board. Bend
the leads at right angles and then
insert the leads into the PC board
with the negative (–) lead and the
positive (+) lead in the correct holes
as marked on the PC board.
Start Here
C3 - 2200µF Lytic
Mount on foil side of PC board
Note the polarity
(see Figure J)
+
Bottom Right Corner of PC Board
Top Right Corner
of PC Board
-8-
Continue
D1 - 1N4001 Diode
D2 - 1N4001 Diode
D3 - 1N4001 Diode
D4 - 1N4001 Diode
D5 - 1N4001 Diode
D6 - 1N4001 Diode
D7 - 1N4001 Diode
D8 - 1N4001 Diode
D9 - 1N4001 Diode
D10 - 1N4001 Diode
(see Figure I)
Figure I
Diodes have polarity. Mount them with
the band as shown on the top legend.
Band
Continue
L-Bracket
(see Figure B)
C7 - .1µF Mylar (104)
(see Figure D)
J5 - Jumper Wire *
(see Figure F)
C9 - .1µF (104) Mylar
(see Figure D)
L-Bracket
(see Figure B)
* Leftover wire will be used in
future sections.
Advertisement
Table of Contents
