When The Washing Program Is Completed, But There Is Water In The Drum; Auto Off Mode - AEG AWF8024M3SB User Manual

20 www.aeg.com
NOTE
At the end of the program, the time
remaining can suddenly decrease from
7 minutes or less to 0 due to the
overestimated total program time during
the load sensing phase. In some cases
(with perfectly balanced load) the
program time can be shorter than the
time estimated after the load sensing
phase is completed. This is a normal
behavior of the machine and not a cause
for concern as it does not compromise its
performance.
5.10 When The Washing
Program Is Completed, But
There Is Water In The Drum
(Option "Rinse Hold
-
The drum turns regularly to prevent
the creases in the laundry.
-
The indicator "Start/Pause" flashes to
remind you to drain the water.
-
The door lock indicator "
The door stays locked.
You must drain the water to
open the door.
To drain the water:
Press the "Start/Pause
1.
The appliance drains the water and
spins with the maximum spin speed
for selected program.
Alternatively, before pressing the
"Start/Pause" touchpad, you can press
the "Spin " touchpad to change the
spin speed. You can select "No Spin
( )", if you want the machine to only
drain the water.
2. When the program is completed and
the door lock indicator "
you can open the door.
3. Turn the program selector knob to the
position "Off" to turn off the appliance.
After approximately 18 hours, if you
do not press Start/Pause touchpad,
the appliance will drain and spin
automatically.

5.11 AUTO Off Mode

5 minutes after the washing program
ends, if you do not deactivate the
appliance, the energy saving function
activates.
The energy saving function decreases
the energy consumption when the
appliance is in the stand by mode.
-
" is used)
-
-
" is on.
" touchpad.
" goes off,
NOTE
All indicators and the display will
switch off.
The indicator of the touchpad
Start/Pause will flash slowly.
Press one of the touchpads to
deactivate the energy saving
status.