Command-Based Control - Sharp PN-40TC1 Operation Manual

Controlling the Monitor with a computer (LAN)

Command-based control

You can control the monitor using RS-232C commands
(see page 31) via terminal software and other appropriate
applications.
Read the manual for the terminal software for detailed
instructions.
(1) Connect the computer to the monitor.
1. Specify the IP address and data port number (10008)
and connect the computer to the monitor.
When connection has been established successfully,
[ Login:] is returned as response.
2. Send the user name.
• Send [User name] + [
• If the user name is not set, send [
• When the transmission is successful, [
is returned as response.
3. Send the password.
• Send [Password] + [
• If the password is not set, send [
• When the transmission is successful, [OK
returned as response.
(2) Send commands to control the monitor.
• The commands used are the same as those for RS-
232C. Refer to the communication procedure (see
page 31) for operation.
• Usable commands are provided in the RS-232C
command table (see page 33).
(3) Disconnect the connection with the monitor and
quit the function.
1. Send [BYE
When the transmission is successful, [goodbye] is
returned and the connection is disconnected.
TIPS
• Connection is automatically disconnected when the
time specified in AUTO LOGOUT TIME elapses over a
no-communication period.
38
E
].
].
].
].
].
Password:]
] is