Continuity Check - Pyle DT-9918T Operating Instruction

3. Press the MODE button until "Ω" appears in the
display.
4. Touch the test probe tips across the circuit or part
under test. It is best to disconnect one side of the
part under test so the rest of the circuit will not
interfere with the resistance reading.
5. Read the resistance in the display. The display will
indicate the proper decimal point, value and
symbol.

CONTINUITY CHECK

WARNING: To avoid electric shock, never measure
continuity on circuits or wires that have voltage on
them.
1. Set the range switch to the
2. Insert the black lead plug into the COM socket and
the red test lead plug into the positive
3. Press the MODE button until "
display.
4. Touch the test probe tips to the circuit or wire you
wish to check.
If the resistance is less than 35Ω, the audible
5.
position.
•)))
" appears in the
•)))
14
socket.
•)))