Table of Contents
Advertisement
Connection on right side
If the hose holders are used, the
Note:
possible hose lengths are reduced!
Available from dealer/customer
service:
Extension for Aqua-Stop or cold
■
water inlet hose (approx. 2.50 m).
Order no. WMZ 2380, WZ 10130,
CZ 11350, Z 7070X0.
Longer supply hose (approx.
■
2.20 m), for standard model.
Water inlet
:
Warning
Danger of death!
There is a risk of electric shock if you
touch live components.
Do not immerse the Aqua-Stop safety
valve in water (it contains an electric
valve).
Notes
Only operate the washer dryer using
■
cold mains water.
Do not connect the machine to the
■
mixer tap of an unpressurised hot-
water boiler.
Do not use a used supply hose. Only
■
use the supply hose supplied or one
that was purchased from an
authorised specialist retailer.
Do not kink or squash the water
■
supply hose.
Positioning and connecting
Do not alter (shorten, cut through)
■
the water supply hose (otherwise its
strength is no longer guaranteed).
Only tighten the screw connections
■
by hand. If the screw connections
are tightened too much with a tool
(pliers), the thread may become
damaged.
Optimum water pressure in the supply
network
At least 100 kPa (1 bar)
Maximum 1000 kPa (10 bar)
When the tap is open, the water flow
rate is at least 8 l/min.
If the water pressure is higher than this,
a pressure-reducing valve must be
installed.
Connection
Connect the water supply hose to the
tap (26.4 mm = ¾") and to the
appliance (not necessary for Aqua-Stop
models as this is permanently installed):
Model: Standard
■
Model: Aqua-Secure
■
en
15
Advertisement
Table of Contents
