Connection To The Drain; Adjusting The Feet - Blomberg GVN39S32 User Manual

Installation
Permitted water temperature: up to
25°C ( 60°C for products equipped
with aquAvoid™ plus; please refer
toaquAvoid™ plus section )
The dishwasher may not be connected
to open warm water devices or flow-
through water heaters.
• Do not use old or used water inlet
hose on the new product. Use the
new water inlet hose supplied with
the product.
• Connect the water inlet hose
directly to the water tap. Pressure
coming from the tap should be
minimum 0.3 and maximum
10 bars. If the water pressure
exceeds 10 bars, a pressure
relief valve should be installed in
between.
• Open the taps completely after
making the connections to check
for water leaks.
C
Use a screw-on hose
connector to connect the
water inlet hose to a water
tap with a ¾ inch external
thread. If required, use a
filter insert to filter deposits
from the pipes.
A
For your safety, close the
water inlet tap completely
after the washing
programme is over.
/47 EN
10

Connection to the drain

Water discharge hose can directly be
connected to the drain hole or sink's
drainage. The length of this connection
must be min. 50 cm and max. 100 cm
from the floor. A discharge hose longer
than 4 meters causes dirty washing.
Attach the water discharge hose
to the drainpipe without bending it.
Tightly fix the water discharge hose to
the drainpipe in order to prevent any
dislocation of the water discharge hose
during operation of the product.
C
Drainpipe must be
connected to the sewage
system and it should not be
connected to any surface
water.

Adjusting the feet

If the door of the product cannot be
closed properly or if the product swings
when you push it slightly, then you
need to adjust the feet of the product.
Adjust the feet of the product as
illustrated in the installation manual
supplied with the product.
Dishwasher / User manual