Clean The Water Inlet Filters - Bosch WAJ240L8SN User Manual And Installation Instructions

Clean the water inlet filters.

Clean the filter in the water inlet in
the event of blockages or if the water
pressure is too low.
Emptying the water inlet hose
Turn off the tap.
1.
Set a programme, except for
2.
Rinse, Spin or Drain.
Start the programme and leave it
3.
to run for approx. 40 seconds.
Switch off the appliance.
4.
Disconnect the appliance's mains
5.
plug from the power supply.
Cleaning the filter on the tap
Note: Please read the information in
the Safety → Page 4 and Preventing
material damage → Page 11 sections
to ensure that you use the appliance
safely.
Requirement: The water inlet hose is
empty.
Remove the water inlet hose from
1.
the tap.
Clean the filter with a small brush.
2.
Cleaning and servicing en
Connect the water inlet hose and
3.
check for leaks.
Cleaning the filter on the
appliance
Note: Please read the information in
the Safety → Page 4 and Preventing
material damage → Page 11 sections
to ensure that you use the appliance
safely.
Requirement: The water inlet hose is
empty.
→ "Emptying the water inlet hose",
Page 41
Disconnect the hose from the rear
1.
of the appliance.
41