Samsung HW-MM36 Full Manual page 17

7. If the SWA-8500S does not connect, take the necessary steps according to the LED Indicator's
status.
On
LINK (Blue)
Blinking
STANDBY
On
(Red)
Others -
LED status
Connected with
the Soundbar
Connection
standby status
Connection
failure
Errors
-
Check if the Soundbar is turned on
Repeat steps 3 through 6.
Check if the Soundbar is turned on
1. Press the ID SET button on the back of the Wireless
Receiver Module with a pen tip for
5~6 seconds until the LINK LED indicator blinks (in
Blue).
L R
SURROUND SPEAKERS OUT
SPEAKER IMPEDANCE : 3
ID SET
2. Repeat steps 3 through 6.
Contact a Samsung Service Center.
ENG - 11
Action
5 Sec
ID SET
POWER