Starting The Programme; Adjusting The "Ready In" Time Before The Programme Starts; Soaking Laundry; Adding Laundry - Bosch WAU28T40ES User Manual And Assembly Instructions

Push in the detergent drawer.
4.

Starting the programme

Note: If you want to change the time
until the programme ends, set the
"Ready in" time first.
Press Inicio/Pausa + Carga
▶
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows either the pro-
gramme duration or the "Ready in"
time.
a After the programme has ended,
the display shows: End.
Adjusting the "Ready in" time
before the programme starts
You can readjust the selected "Ready
in" time before the programme starts.
Press Inicio/Pausa + Carga
1.
Press Termin.
2.
the display indicates the desired
"Ready in" time.
Press Inicio/Pausa + Carga
3.

Soaking laundry

You can soak the laundry before
washing in the appliance by pausing
the programme.
Note: No additional detergent is re-
quired. The washing solution is then
used for washing.
Start the programme.
1.
To pause the programme, after ap-
2.
prox. 10 minutes, press Inicio/
Pausa + Carga
To resume the programme, after
3.
the desired soaking time, press
Inicio/Pausa + Carga
.
.
repeatedly until
.
.
.

Adding laundry

Note: Please read the information in
the "Safety" → Page 4 and "Prevent-
ing material damage" → Page 11 sec-
tions to ensure that you use the appli-
ance safely.
Press Inicio/Pausa + Carga
1.
The appliance is paused and
checks whether it is possible to
add or remove laundry. Take note
of the programme status.
→ "Display", Page 21
Add or remove laundry.
2.
Close the door.
3.
Press Inicio/Pausa + Carga
4.

Cancelling the programme

Once the programme has started,
you can cancel it at any time.
Note: Please read the information in
the "Safety" → Page 4 and "Prevent-
ing material damage" → Page 11 sec-
tions to ensure that you use the appli-
ance safely.
Press Inicio/Pausa + Carga
1.
Open the door.
2.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the programme.
– If the water level is high: Start
the or
Remove the laundry.
3.
Resuming the programme
when the programme status
is Rinse Hold
Set the or
1.
Press Inicio/Pausa + Carga
2.
Basic operation en
programme.
programme.
.
.
.
.
37