Table of Contents
Advertisement
•
- No communication between electronic elements of the appliance. Switch it
off and switch on again. The programme was not finished properly or the appliance
stopped too early. If the alarm code appears again, contact the Authorised Service
Centre.
•
- The anti-flood device is on. Disconnect the appliance and close the water
tap. Contact the Authorised Service Centre.
•
- The appliance does not fill with water properly. After the proper check, start
the appliance again by pressing Start/Pause
resume the cycle . If the error persists the alarm code will appear again.
•
- The appliance does not drain the water.
•
- The appliance door is open or not closed correctly. Please check the door!
If the appliance is overloaded, remove some items from the drum
and/or hold the door shut while touching the Start/Pause
until the indicator
13.2 Possible failures
Problem
The programme does
not start.
stops flashing (see the picture below).
Possible solution
• Make sure that the mains plug is connected to the
mains socket.
• Make sure that the appliance door is closed.
• Make sure that there is no damaged fuse in the fuse
box.
• Make sure that the Start/Pause
• If the delay start is set, cancel the setting or wait for the
end of countdown.
• Deactivate the Child Lock function if it is on.
• Check the position of the knob on the selected pro‐
gramme.
button the appliance tries to
button
has been touched.
ENGLISH
39
Advertisement
Table of Contents
