Advertisement
10/19
4. OPERATION
Fig 18 Installing Drills
1. Insert drill into chuck jaws approx. 1" (25.4mm) long.
When using a small drill do not insert too far for the
jaws to tough the flutes of the drill. Make sure that the
drill is centred in the chuck before tightening the chuck
with the key.
Fig 19 Workpiece Positioning
1. Always place a piece of wood (or plywood) on the table
to prevent "splintering" and/or burrs on the underside
of the workpiece as the drill breaks through. Position
the wood so that it is in contact with the left side of the
column
Vice Positioning
1. For small workpieces that cannot be clamped to the table, use a drill press vice. The vice
must be clamped or bolted to the table.
5. INSPECTION
Prior to each use conduct a visual inspection checking for abnormal conditions, such as cracked
welds, leaks, and damaged, loose, or missing parts.
The drill press shall always be maintained in accordance with the maintenance instructions. No
alterations or modifications shall be made to this drill press.
Inspections shall be performed in accordance with this owner's manual.
The drill press must be inspected immediately if it is believed to have been subjected to abnormal
load or shock.
Owners and /or operators should be aware that repair of this product may require specialised
equipment and knowledge (refer to maintenance section).
6. STORAGE
This drill press should always be stored in a dry location on a level surface with the power switched
off.
7. MAINTENANCE
1. DISCONNECT Drill Press before performing any maintenance
2. FREQUENTLY blow out any dust that may accumulate inside the motor
3. APPLY a coat of automobile type wax or similar to the table and column to keep surface clean
4. LUBRICATION; all the ball bearings are packed with grease at the factory. They require no further
lubrication
5. PERIODICALLY lubricate the gear and rack table elevation mechanism, the splines (grooves) in
the spindle and the rack (teeth on the quill)
6. Only use replacement parts that are approved by the manufacturer.
7. Regularly clean all surfaces and maintain all labels and warnings.
Made in China to TQB Brands Pty Ltd specifications
Visit us at www.tqbbrands.com.au
CH18FT
P a g e
| 8
Advertisement
