Model No. As-101K-8 (380/460V, 3 Phase, 1/2 - 10 Hp) - InSinkErator AquaSaver AS101 Installation Manual

ELECTRICAL SHOCK
• Turn off the electrical supply to the disposer before
attempting any work on it. Use a voltmeter or
circuit tester to ensure that power is off.
• Installation must conform to local electrical codes.
• All control centers and disposers must be carefully
and permanently grounded.
• A properly fused disconnect must be installed at
the electrical supply source for the control center.
Call Toll Free 1-800-845-8345
for the nearest InSinkErator
Authorized Service Agency or
to reach Technical Support.
AS-101K-8 Wiring Diagram
P/N 15255C
• Ensure that the control center voltage and phase
• The disposer motor wiring connection is shown in
Note: • Red wires = Low voltage (24 V) control.
12
PROPERTY DAMAGE
match the disposer motor and electrical supply.
Check nameplates on disposers and control
centers for voltage and phase specification.
the disposer terminal box.
• Black wires = Line voltage (380 - 460 V) control.
AS-101K-8
380/460 V
3-phase
1/2 to 10 HP