I. DÉBALLAGE II. POSITIONNEMENT DES ENCEINTES Elipson maintient un contrôle de qualité strict, et tous les produits quittent notre usine en Intégration au plafond parfait état. Si des dommages sont visibles ou cachés à l’ouverture, ils ont eu lieu lors de la manutention et doivent être signalés immédiatement à...
IV. INSTALLATION 4. Découpe de montage Attention : Cette étape est la plus importante de toute l’installation. Si vous n’êtes pas sûr des obstacles présents dans la zone de découpe, commencez par découper un Préparation des surfaces / finition des plafonds petit trou dans la zone de découpe avec une scie à...
Page 4
Le tissu arrière doit être retiré avant de peindre les grilles. La surface doit être nettoyée avec un solvant doux afin d’éliminer la poussière et résidus éventuels. Elipson vous recommande de peindre à l’aérosol avec un mélange de 5 volumes d’agent diluant pour...
Définition de la garantie Type Enceinte encastrable plafond Enceinte encastrable plafond La garantie est limitée à la réparation de l’équipement Elipson. En aucun cas, le transport, les coûts associés ainsi que l’installation ne sont couverts par la garantie. Puissance 100 W 130 W La garantie n’est applicable qu’au premier propriétaire et n’est pas transférable.
Page 6
I. UNPACKING II. PLACEMENT Elipson keeps to a strict quality control regimen and all factory-sealed products leave our facility in perfect condition. If there are any damages visible or concealed they have occurred in handling and must be reported immediately to your Elipson authorized dealer.
Page 7
IV. INSTALLATION 4. Cutting the hole Caution : this is the most important part of the entire installation. If you are uncertain about obstructions in the mounting area, you should start by cutting a small hole within the Preparation of mounting surfaces / Finishing of ceilings penciled area with a drywall saw.
The surface should be cleaned with a light solvent to remove any dust or residue. Elipson recommends a light spray-painting using 5 parts thinning agent to 1 part paint. Do not paint the grill while they...
Impedance 8 Ohms 8 Ohms To claim repair under warranty To claim repair or service under warranty you simply have to contact your local Elipson dealer, from whom your equipment 3200 Hz 2500 Hz Crossover frequency has been purchased. To ensure that you will be able to ship your damaged product in correct manner, always retain the original packaging of your Elipson equipment.
Need help?
Do you have a question about the INFINITE INF6 and is the answer not in the manual?
Questions and answers