Electric Hotplates; Before Using For The First Time; Operation; Switching Off - Bosch NCT615C01 Installation Instructions Operating And Assembly Instructions Manual

4 zone sealed plate electric hob brushed steel
Hide thumbs Also See for NCT615C01 Installation Instructions:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 11

Electric hotplates

Before using for the first time

Operation

Switching on

Switching off

Residual heat
12
Do not clean the appliance using steam cleaners. Risk of
electrocution!
The graphics in this instruction manual are given as a
guide only.
To remove the new smell, switch the hotplates on to full
power for five minutes, one by one, without placing any
pans on top. Do not switch more than one hotplate on at
a time. At this point it is normal to notice smoke and
odours, but these will disappear over time.
Caution! Do not operate the hotplates without placing
pans on top, except during this initial heating phase.
Turn the knob anticlockwise to the required setting.
Fig. 1 or 2 depending on the model.
Setting 1: low power.
Setting 6 or 9 (depending on the model): full power
Turn the knob clockwise to the off setting.
Tip It is recommended to start cooking on full power and
then to use intermediate power levels after a few
minutes.
The electric hotplates can be switched off slightly before
the end of the cooking time. The residual heat will enable
you to continue cooking for several minutes, thus saving
energy.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the NCT615C01 Installation Instructions and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Nct612c01 installation instructionsNct616c01 installation instructionsNct615c01Nct612c01

Table of Contents