Table of Contents
Advertisement
3
• The pulsator rotates for
50seconds to detect the
laundry load.
• Then the WATER LEVEL
and the amount of
Detergent to be used will
be shown and water will
be supplied.
4
4
4
4
• The pulsator rotates for 50seconds
to detect the laundry load.
• Then the WATER LEVEL and the
amount of Detergent to be used
will be shown and water will be
supplied.
Close the lid
5
• Water will be
• When the wash
supplied for 2
program ends, the
minutes after the
buzzer will ring
start of the wash to
for 10 seconds
supplement the
before the Power
water the laundry
goes off
has absorbed.
automatically.
6
6
6
6
Finish
• If water is already in the tub, or putting
6
wet laundry into the tub before starting
will increase the WATER LEVEL.
• With lightweight bulky loads, WATER
LEVEL can be set low.
• Changes to Water Temperature
(HOT/COLD) and wash level are
possible during operation.
• When setting the WATER LEVEL
7
manually, do not set to Medium to
prevent damage to laundry.
• Washing with HOT water may damage
the laundry (Water is set to cold
automatically). Ensure that the load is
under 2kg.
• In order to avoid damage to laundry,
the spin cycle may appear slow.
This also avoids wrinkles and clothing
may still contain some water. This is
normal.
• When static pressure of water is more
than 2kg/cm
7
will be within 19min.
• Never wash electric blanket and carpet. (It
7
can damage the washer and laundry itself.)
• Cashmere blanket, acryl blanket, mixed
weaved blanket, wool blanket, blanket
filling (Polyester 100%) and bed sheet can
be damaged when they float on the water
during the wash. Therefore purchase a
separate wash net to wash in.
• The course will automatically be set at warm water
and safe rinse of 3 times to wash the clothes more
7
effectively, the wash time may slightly be extended.
• During the rinse cycle, the drum will rotate while the
water is supplied, repeating the "Water supply – Drum
mix – Drain" course 3 times. Water supply and
drainage happens simultaneously during the rinse
cycle and this is normal.
• WARM WATER is automatically set by adding cold
and Hot Water Appropriately to maintain the water
temperature at an appropriate level.
Caution & Note
, the QUICK WASH course
2
17
Advertisement
Table of Contents
