Carburetor Linkage; Engine Break-In - 3W 85i B2 Manual

Important: Do not remove the carburetor spring as the spring helps keep the carburetor butterfly
aligned properly. Merely release the ends of the spring so that it no longer holds the butterfly
closed.

Carburetor Linkage

Included with your engine is a metal bracket to extent your carburetor pushrod horn. Fix this
bracket onto the carburetor horn with a 2.6m machine screw and nut. Then solder the arm in place.
Refer to the attached illustration.
Note: The use of a soft pushrod for the throttle (plastic or nyrod) is not recommended. Use a metal
or carbon fiber pushrod with a plastic ball joint or plastic clevis at each end. This will keep your
RPM much more consistent and accurate around idle where it really counts.
Engine Break In
•
Use a 2-stroke petroleum based oil (preferably ashless) as this type of oil has a good
honing effect which helps to break in the engine
•
Use a mixture of 32-1 or even 30-1
•
Use this fuel mixture for approximately 2-3 hours of run time
•
Use a high Octane unleaded fuel (98 Octane is ideal)
3W 85i Engine Manual
low speed needle L:
more infos: www.3w-modellmotoren.de
1 1/2