Special Gas Requirements (Gas Models Sold In Massachusetts); Electrical Requirements - Samsung NA36N9755 Installation Manual

The pressure regulator located at the inlet of the cooktop manifold must remain in
the supply line regardless of whether natural or LP gas is being used.
NOTE
• The cooktop comes from the factory with a regulator in the shipping carton. Use
only the regulator provided. The regulator must be installed in the gas line that
runs from the cooktop gas inlet to the gas shut off valve.
• An external manual shut-off valve must be installed between the gas inlet and
the cooktop for the purpose of turning on or shutting off gas to the appliance.
• Be sure the connectors are installed when you need coupling by a qualified
installer.
• Never reuse old connectors when installing the cooktop. The use of old
connectors can cause gas leaks and personal injury. Always use new flexible
connectors when installing a gas appliance.

Special gas requirements (gas models sold in Massachusetts)

COMMONWEALTH OF MASSACHUSETTS REQUIREMENTS:
WARNING
Gas leaks may occur in your system, creating a dangerous situation.
– Gas leaks may not be detected by smell alone.
– Gas suppliers recommend you purchase and install a UL-approved gas detector.
Gas detector should be installed in accordance with the manufacturers
instructions.
• Cooktop must be installed by a qualified plumber or gas fitter by the State of
Massachusetts.
• A T-handle manual gas valve MUST be installed in the gas supply line to your
cooktop.
• If a flexible gas connector is used to install your cooktop, multiple flexible gas
lines must not be connected in series.
Install_NA36N9755TM_DG68-01092A-02_EN+MES+CFR.indb 13

Electrical requirements

WARNING
• It is the owner's responsibility to make sure that the electrical service meets
electrical requirements and that he electrical outlet has been properly installed
by a licensed electrician.
• To reduce the risk of fire, electric shock, or personal injury:
All cooktops
• Do not use an extension cord or adapter plug with this cooktop.
• This cooktop must be properly grounded.
• Check with a qualified electrician if you are in doubt as to whether your cooktop
is properly grounded.
• Do not modify the plug provided with your cooktop — if it doesn't fit the outlet,
have a proper outlet installed by a qualified electrician.
• All wiring and grounding must be done in accordance with local codes or, in the
absence of local codes, with the National Electrical Code, ANSI/NFPA No. 70 –
Latest Revision (for the U.S.) or the Canadian Electrical Code CSA C22.1 – Latest
Revisions and local codes and ordinances.
• Wiring diagram is located on the inside of the burner box.
• This cooktop is equipped with an electronic ignition system that will not operate
if plugged into an outlet that is not properly polarized.
Gas cooktops
• All gas models are equipped with a power cord with an equipment-grounding
conductor and a grounding plug.
• A 120-Volt, 60-Hz, AC, approved electrical service with 20-amp circuit breaker or
time-delay fuse is required for all U.S. and Canadian models.
English 13
10/24/2018 4:47:14 PM