Operation; Specification - Fenton SPA800 Instruction Manual

OPERATION:

Connect the passive speaker with the delivered speaker cable to the speaker output connector
(21). WARNING: only connect the original slave speaker on the speaker output terminal!
If required connect an external signal source like a CD-layer to LINE IN.
Connect the device with an electric outlet (230VAC / 50Hz)
LINE INPUT (DVD, CD-player etc.):
1. Connect the source (DVD-player, CD-player etc.) to the line input (22) on the rear panel
2. Press the SOURCE selector button (11) to select the line input
USB/SD:
1. Insert an USB (9) or SD device (10). The player will automatically starts playing the files
that are on the inserted device
MICROPHONE:
1. Insert the microphone to the MIC1 or MIC2 jack (4)
2. Adjust the MIC volume (7)
3. Adjust the echo (6) and delay (5) control
Volume control can be adjusted with the master VOLUME (8) Make sure that when you turn
on the active speaker's volume control is minimal.
Adjust the Equalizer (1+3) to get the right sound

SPECIFICATION

Frequency Response: ...................................................... 40Hz-20kHz ± 3dB
Input Sound Source: ...................................................................... Line Input
Speaker: ........................ 8 inch Woofer & Piezo Tweeter (170.143/170.152)
..................................... 10 inch Woofer & Piezo Tweeter (170.146/170.155)
..................................... 12 inch Woofer & Piezo Tweeter (170.149/170.158)
Car reader memory medium: ......................................... MMC Card, SD Card
Power supply: ..................................................................... 230VAC at 50Hz