Attachment Of The Cp-Xy3Wb1 Wheel Board - Pioneer XY-3B-W User Manual

Attachment of the CP-XY3WB1 Wheel Board

3
2
1 Butterfly latch
2 Locking castor
3 Guide for stacking
Attach the wheel board to the front of the enclosure using the butterfly latches on
both sides of the wheel board.
You can use the wheel boards to stack two enclosures. Before stacking, lock the
locking castor, then place the upper enclosure on top so that the wheel board guides
on the underside of the upper enclosure fit firmly into the lower enclosure.
WARNING
! When attaching the wheel board to the enclosure, securely tighten the butter-
fly latches to the brackets on the sides of the enclosure.
! When attaching the wheel board to the enclosure, be sure to attach it so that
the locking castor side is on the bottom side of the enclosure.
! The work to raise up and lower down the enclosure for transportation must be
performed by two or more people. Also, when raising up the enclosure after
transportation, be sure to lock the locking castors.
! Be sure to lock the locking castors except during transportation.
Additionally, do not place the enclosures in a sloping location.
1
! When stacking, do not use any other method than that specified in the user's
manual. Additionally, do not stack more than three deep, stack in a sloping
location, or stack any products other than the XY-3B.
! Stacking work should always be performed by two or more people.
! When stacking, apply the locking castor locks firmly. Additionally, after stack-
ing, check that the guide on the underside of the wheel board on the upper
enclosure is fit firmly into the enclosure on the underside.
9
Engb