Audio - LG HTK805TH Owner's Manual

Audio

5.1 Speaker Setup
Make the following settings for the built-in 5.1
channel surround decoder.
1. Select [5.1 Speaker Setup] on the [Audio]
menu.
2. Press  ENTER.
The [5.1 Speaker setup] appears.
3. Use I i to select the desired speaker.
4. Adjust options using U u I i buttons.
5. Returns to the previous menu by pressing
O RETURN.
HTK805TH-FK_DRUSLL_ENG_6932.indd25 25
[Speaker selection]
Select a speaker that you want to adjust.
NOTE
Certain speaker settings are prohibited by the
Dolby Digital licensing agreement.
[Size]
Since the speaker settings are fixed, you
cannot change the settings.
[Volume]
Press I i to adjust the output level of the
selected speaker.
Front L/R : 0 ~ -5
SubWoofer, Rear L/R, Center : 5 ~ -5
[Distance]
After you connected speakers to your unit,
set the Distance between the speakers and
your listening point if the distance of Center
or Rear speakers is bigger than the distance
of Front speakers. This allows the sound
from each speaker to reach the listener
at the same time. Press I i to adjust the
Distance of the selected speaker. This
distance is equivalent to a difference of the
distance between Center or Rear speaker
and Front speakers.
[Test]
Select [Speaker Test Start] by using the U u
and press  ENTER. Press  ENTER again
to stop. Adjust the volume to match the
volume of test signals memorized in the
system.
DRC (Dynamic Range Control)
Make the sound clear when the volume is
turned down (Dolby Digital only). Set to [On]
for this effect.
Installation 
3
2010-02-22 ¿ÀÈÄ 6:27:17