Advertisement
Shop-Vac warrants the vacuum cleaner for two years from the date of purchase to correct by repair or parts replacement without charge, any
product defect due to faulty material or workmanship provided that the vacuum cleaner is not used for rental service. This warranty does not
cover accessories. Simply return the complete unit, (transportation prepaid), to the Authorized Shop-Vac Service Centre nearest you (a complete
list of Authorized Shop-Vac Service Centres is included with each vacuum cleaner). Shop-Vac assumes no responsibility for damage or faulty
performance caused by misuse or careless handling, or where repairs have been made or attempted by others. Proof of purchase date is
required. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. Our goods come with
guarantees that cannot be excluded under the Australian Consumer Law.You are entitled to a replacement or refund for a major failure and for
compensation for any other reasonably foreseeable loss or damage.You are also entitled to have the goods repaired or replaced if the goods fail
to be of acceptable quality and the failure does not amount to a major failure.
This appliance must be grounded. If it should malfunction or
breakdown, grounding provides a path of least resistance for electric
current to reduce the risk of electric shock. This appliance is
equipped with a cord having an equipment-grounding conductor and
grounding plug. The plug must be inserted into an appropriate outlet
that is properly installed and grounded in accordance with all local
codes and ordinances. This appliance is for use on a nominal
240-volt circuit, and has a grounded plug that looks like the plug
illustrated in sketch A.
WARNING
–
EQUIPMENT-GROUNDING CONDUCTOR CAN RESULT IN A RISK OF
Use only a cord extension set that complies with AS3199. Conductor size must be 1.0mm
from 25 - 32 metres.
NOTE:
STATIC SHOCKS ARE COMMON IN DRY AREAS OR WHEN THE RELATIVE HUMIDITY OF THE AIR IS LOW. THIS IS ONLY TEMPORARY AND
DOES NOT AFFECT THE USE OF THE APPLIANCE. TO REDUCE THE FREQUENCY OF STATIC SHOCKS IN YOUR HOME, THE BEST REMEDY
IS TO ADD MOISTURE TO THE AIR WITH A CONSOLE OR INSTALLED HUMIDIFIER.
1.
Remove tank cover and any accessories which may have been
shipped in the tank.
2.
Before replacing tank cover, please refer to DRY PICK UP or WET
PICK UP OPERATION in this manual to ensure you have the proper
filters installed for your cleaning operation.
3.
Replace tank cover.
4.
Slip cleaner end of flexible hose into the intake port.
REAR WHEEL DOLLY/TOOL HOLDER AND FRONT CASTER ASSEMBLY
You will find two casters (a), two large rear wheels (b), two axles (c), two hub caps (d), one tool holder (e) and four screws with your wet/dry
vacuum. Assemble as follows:
a
LIMITED TWO-YEAR WARRANTY
GROUNDING INSTRUCTIONS
IMPROPER CONNECTION OF THE
EXTENSION CORDS
UNPACKING AND SET-UP
b
ELECTRIC SHOCK. CHECK WITH A
QUALIFIED ELECTRICIAN OR
SERVICE PERSON IF YOU ARE IN
DOUBT AS TO WHETHER THE
OUTLET IS PROPERLY GROUNDED.
DO NOT MODIFY THE PLUG
PROVIDED WITH THE APPLIANCE –
IF IT WILL NOT FIT THE OUTLET,
HAVE A PROPER OUTLET
INSTALLED BY A QUALIFIED ELECTRICIAN.
NOTE:
If power cord needs to be replaced, use only a Shop-Vac
Service Agent.
2
for length up to 25 metres and 1.5mm
5.
Attach the extension wands to the accessory end of the hose.
Twist slightly to tighten the connection.
6.
Attach one of the cleaning accessories (depending on your
cleaning requirements) to the extension wand. Twist slightly to
tighten the connection.
7.
Plug the cord into the wall outlet. Your cleaner is ready for use.
I = ON O = OFF
c
d
Grounded
Outlet
(A)
2
for length
e
Grounding
pin
Advertisement
