Dremel 3D40-EDU Operating/Safety Instructions Manual page 29

Find Quality Products Online at:
BEFORE YOU BUILD
1. Ensure an adequate amount of filament is
loaded (see page 24).
TIP: You can determine whether you have
enough filament to complete your object
before building by comparing the length of
filament needed as displayed by Print
Studio to the length of filament on spool
indicated by the length gauge.
If 3D40 runs out of filament during a build,
it will pause until more filament is added.
2. Ensure build tape is applied, build platform
is level and clear of objects.
BUILDING FROM
ON-PRINTER STORAGE
1. On the main menu tap "Build".
2. On the build menu tap the printer icon.
3. Tap the model file you would like to build.
(Use arrows to scroll through pages)
GlobalTestSupply
www.
4. In the model detail page tap "Build" to
begin building process.
5. Your 3D40 will first align the extruder and
build platform to their zero positions then
the level sensor will lightly touch the build
platform to complete alignment. Your
extruder tip will begin to heat which may
take a few minutes. Once the proper
temperature is reached your model will
begin to build.
6. Once your object is finished your 3D40 will
automatically align the extruder and build
platform to their calibration positions and
cool the extruder tip.
7. Wait until the touch screen indicates that
the extruder is "cool" to remove your
object. See section for removing object
from build platform below for object
removal instructions.
29
.com
sales@GlobalTestSupply.com