Monte Carlo Fan Company 5BHM60 Series Owner's Manual And Installation Manual page 7

Blade installation
Install blade bracket with blade by 3 blade screws and washers provided.
Tighten screws securely. Repeat this process for remaining blades. (Fig. 9)
Remove shipping stabilizers from motor assembly.
Install the blade assembly to motor using the preinstalled screws. Tighten
screws securely. Repeat this process for remaining blade assemblies. (Fig. 9)
Note: Tighten blade bracket screws twice a year.
Switch housing installation and wiring
Loosen 2 and remove one set screws from the plate on motor, keep screw.
Attached top switch housing onto the plate on motor, aligning its keyhole
slots with the set screws on the plate and twist clockwise until tight. Reinstall
the screw which is just removed and tighten all screws securely. (Fig.10)
Attach capacitor onto top switch housing by preadhered double-sided foam
tap as shown.
Connect the plug from fan to the plug from switch housing, aligning the claps
and make sure plugs connected securely. (Fig. 10-1)
Remove 4 set screws from top switch housing, keep screws.
Align the long slot on top switch housing with the reverse switch on switch
housing, install the switch housing onto the fan with the 4 side
and then
mount screws which were just removed.
Plate on motor
Set screws
Fig. 10
Install fan pull chain to preassembled pull chain on fan.
Pull chain provided. (Fig. 11)
Forward/Reverse switch setting
Setting the reverse switch in the right hand side will
result in downward airflow and setting the switch in the
left hand side will result in upward airflow.
Note: Reverse switch must be set either way
completely. If the reverse switch is set in the middle
position, fan will not operate. (Fig. 11)
Operation and Maintenance
Refer to operation and maintenance on the second page
of parts list.
© 2013 Monte Carlo Fan Company
Capacitor
Set screws
Long slot
Reverse switch
Top switch housing
Switch housing
shipping stabilizers
Capacitor
Set screws
Fig. 10-1
7
Screws
Washers
Screws
Blade
Blades bracket
Fig. 9
Fig. 11
Pull chain
Reverse switch
9/1/2013 /2013