Table of Contents
Advertisement
EXTERNAL EQUIPMENT SETUP
!
NOTE
To enjoy vivid picture and sound, connect a PC
G
to the TV.
Avoid keeping a fixed image on the TV's screen
G
for prolonged periods of time. The fixed image
may become permanently imprinted on the
screen; use a screen saver when possible.
Connect the PC to the RGB (PC) or HDMI IN (or
G
HDMI/DVI IN) port of the TV; change the
resolution.
There may be interference relating to resolution,
G
vertical pattern, contrast or brightness in PC
mode. Change the PC mode to another resolu-
tion or change the refresh rate to another rate or
adjust the brightness and contrast on the menu
until the picture is clear. If the refresh rate of the
PC graphic card can not be changed, change the
PC graphic card or consult the manufacturer of
the PC graphic card.
The synchronization input waveform for
G
Horizontal and Vertical frequencies are separate.
We recommend using 1024x768, 60Hz for the
G
PC mode, these should provide the best picture
quality.
Connect the signal cable from the monitor out-
G
put port of the PC to the RGB (PC) port of the
TV or the signal cable from the HDMI output
port of the PC to the HDMI IN (or HDMI/DVI
IN) port on the TV.
20
Connect the audio cable from the PC to the
G
Audio input on the TV. (Audio cables are not
included with the TV).
If using a sound card, adjust PC sound as
G
required.
This TV uses a VESA Plug and Play Solution. The
G
TV provides EDID data to the PC system with a
DDC protocol. The PC adjusts automatically
when using this TV.
DDC protocol is preset for RGB (Analog RGB),
G
HDMI (Digital RGB) mode.
If required, adjust the settings for Plug and Play
G
functionality.
If the graphic card on the PC does not output
G
analogue and digital RGB simultaneously, connect
only one of either RGB or HDMI IN (or
HDMI/DVI IN) to display the PC output on the
TV.
If the graphic card on the PC does output
G
analogue and digital RGB simultaneously, switch
the TV to either RGB or HDMI; (the other mode
is set to Plug and Play automatically by the TV.)
DOS mode may not work depending on the
G
video card if you use a HDMI to DVI cable.
If you use too long an RGB-PC cable, there may
G
be interference on the screen. We recommend
using under 5m of cable. This provides the best
picture quality.
Advertisement
Table of Contents
