Removal And Installation; Turbocharger Weight; Removing The Turbocharger; Table 3: Total Weight - ABB XAC24782 Operation Manual

Operation Manual / A100-L
3 Removal and installation / 3.1 Turbocharger weight
3

Removal and installation

3.1

Turbocharger weight

Lifting gear with a sufficient load limit must be used for removing, installing and transport-
ing the turbocharger. The weight specified below applies to the heaviest variant possible.
Depending on the specification, the weight specified on the rating plate may be lower than
the standard value specified here.
Product
A165-L
A170-L
A175-L
A180-L
A185-L
A190-L
Table 3: Total weight
3.2

Removing the turbocharger

WARNING
Risk of tipping
If the turbocharger is not sufficiently supported or not supported at all dur-
ing removal and installation, it may tip over and cause severe injury to per-
sonnel or accidents resulting in fatalities.
Support the turbocharger at a suitable location.
u
Secure with lifting gear wherever possible.
u
Loosen cable to speed sensor.
u
Disconnect all pipes according to the instructions of the enginebuilder.
u
Check lifting gear.
u
Attach lifting gear to the turbocharger and tauten.
u
© Copyright 2021 ABB. All rights reserved.
Weight of complete turbocharger unit [kg]
HZTL4034_EN
2300
3300
5600
7500
10500
13500
Rev.T December 2021