Samsung CT29Z40 Owner's Instructions Manual page 3

Setup - Plug & Play
(depending on the model)
When the TV is initially powered on, several basic customer
settings proceed automatically and subsequently.
The following settings are available.
1 Press the PoWEr button on
the remote control.
The message "Start Plug
& Play" is displayed. It
flickers for a little while and
then Language menu is
automatically displayed.
Language
2 Press the ▲ or ▼ button to
English
Español
select the language, then
Português
Français
press the ENTEr button. The
message "Check antenna
input" is displayed.
Move
➢
If any language is not
selected, the language
menu will disappear
Check antenna input.
about 30 seconds later.
3 Make sure that the antenna is
Auto Program
connected to the TV.
Press the ENTEr button,
then the "Auto Program" is
displayed.
Enter
4 Press the ENTEr button to
Auto Program
select "Start". The TV will Air 3
begin memorizing all of the
available channels. Press the
ENTEr button to stop.
Enter
5 After all available channels
are stored, the "Clock set" is
displayed. Press the ENTEr
button. Press the ◄ or ►
Plug & Play
button to move to the hour
Start Plug & Play
or minute. Set the clock by
OK
pressing the ▲ or ▼ button.
Enter Exit
6 When you have finished,
press the MENU button.
Plug & Play
The "Enjoy your watching."
is displayed and then the
channel which has been
stored will be activated.
Enter Skip
➢
Plug & Play feature
Plug & Play
doesn't work in the AV
and component mode.
OK
Enter Skip
Re-setting the Plug & Play
Method:
Plug & Play MENU  ▲/▼ (Setup) 
ENTEr  ▲/▼ (Plug & Play) 
ENTEr
0%
Start
Skip
Plug & Play
7 %
Stop
Skip
continued...
Plug & Play
Clock Set 12:00 am
Move Enter
Adjust Skip
Enjoy your watching.
OK
Setup
TV
Plug & Play ►
Language : English ►
Time ►
Caption : Off
Child Lock ►
Blue Screen : Off ►
Melody : On ►
Music Mode : Off ►
Move Enter Return
English - 3
Input - Source list
 Source list
TV
You can switch between
TV
AV1
viewing signal from connected
AV2
equipment, such as a VCR, Component
DVD, set-top box, and the TV
source (broadcast or cable).
➢
Press the SoUrCE
Move
button on the remote
control repeatedly to select the desired signal source.
➢
To return to the TV mode, press the SOURCE button
on the remote control.
Source List
Enter Return