Advertisement
HOW TO USE
SUPER CLIP XTP
OILING THE BLADES
To get the sharpest, most precise cut, it is highly recommended to oil the blades
before each use.
• Using the oil supplied with your new tool, unscrew the cap & cut off the very
end of the plastic tube with a pair of scissors to release the oil.
• Switch your tool on, gently squeeze the oil tube & apply 2 drops of oil onto
the blades. Leave the tool on for a further few seconds to allow the oil to
thoroughly spread across each of the blades. Switch off the tool & remove
any excess oil by gently dabbing with a cloth.
BEFORE USING
• Always inspect the clipper blades for noticeable signs of damage.
• Ensure the clipper blades are well oiled before using.
• Always inspect the clipper blades before use to ensure they are free from
hair, debris etc.
• Ensure the clipper is sufficiently charged before use.
• For best performance use on clean, dry hair that has been combed until
tangle-free.
5 POSITION TAPER CONTROL
The 5 position taper control for is designed for blending layers & a precise close
trim, everytime.
• To increase the cutting length, push the lever down.
• To reduce the cutting length, push the lever up.
SUPER CLIP XTP / TOOL TIPS
9
Advertisement
