Table of Contents
Advertisement
16. REINSTALL BAFFLE FILTERS
Remove protective plastic film covering filters before installing them.
NOTES : 1. On 42" width model only, reinstall both filter fillers previously removed in step 5.
2. Assemble the metal handles to the filters, using provided no. 8-32 x 1/4" screws, before installing them in the power pack.
It is recommended to install side filters first and finish with center one(s).
1.
Insert one end of the filter into the
upper channel of the power pack.
2.
Raise the other end toward the
inside of power pack and insert in
the grease drip rail of the power pack.
17. LIGHT BULBS
This power pack must use shielded halogen lamps (120 V, 50 W, MR16 with GU10 base or PAR16 with GU10 base), included.
NOTE: Before using lamps, remove shipping tape on them (if present).
In order to prevent the risk of personal injury, do not install a lamp
identified for use only in enclosed fixtures.
1. Install the lamps by placing the bulb leads into their grooves in the socket.
2. Gently push upwards and turn clockwise until secure.
In order to prevent the risk of personal injury, the halogen lamps must
be cooled down before removing them.
To remove lamps, gently push upwards and turn counterclockwise to disengage bulb leads from their grooves.
NOTE: If need be, use a rubber dishwashing glove to add grip when removing the bulb.
CAUTION
1
HD0299
WARNING
!
WARNING
!
- 11 -
2
1
HO0090
2
Advertisement
Table of Contents
