Table of Contents
Advertisement
MAINTENANCE
CLEANING AND REPLACING THE BASE FILTERS
For best results, regularly clean and replace the filters in the base.
To clean filters, rinse with cold water ONLY to prevent damage from cleaning chemicals. Allow all filters to
air-dry for at least 24 hours before reinstalling them to prevent liquid from being drawn into electric parts.
IMPORTANT: DO NOT use soap when cleaning the filters.
CLEAN PRE-MOTOR FILTERS ONCE A MONTH
To access the pre-motor filters, remove the cover
on the side of the base. Press both slots at the same
time and pull off the cover. Lift out the foam filter by
the handle, and then remove the felt filter underneath.
Tap the filters clean over the trash, then rinse them
with cold water only, as soap or other cleaners may
damage them. Allow the filters to air-dry for 24 hours
before reinstalling.
The filters must be installed correctly for the base to
work properly. Reinsert the felt filter first, then the
foam filter. To reattach the cover, align the bottom of
the cover with the slot on the base and press firmly
until it clicks into place.
NOTE: The pre-motor foam and felt filters should be replaced every 2.5 years. The post-motor filter should be replaced every 3 years.
NOTE: Clean the mesh filter inside the dust bin with a small brush once a month.
s h a r kc l e a n . c o m
Filter
Door
CLEAN POST-MOTOR FILTER EVERY YEAR
Press the button at the top of the Filter Door, then
tilt the door and lift it off. Remove the Post-Motor
Filter from the base. To reinstall the post-motor filter,
insert it into the base and replace the filter door.
MAINTENANCE
SELF-CLEANING BRUSHROLL
The Self-Cleaning Brushroll removes debris over time as it cleans. If some debris remains wrapped around
the brushroll, continue cleaning to allow the brushroll to remove it.
If some debris remains on the brushroll after continued cleaning, follow the steps below to remove it.
To access the brushroll, push up on the tabs on the
brushroll access door, then lift off the door.
NOTE: When cutting away debris, be sure not to cut the brushroll.
NOTE: Replace brushroll every 6 to 12 months, or when visibly worn. See sharkaccessories.com for replacement parts.
Lift out the brushroll, and clean off any debris.
Reinstall the brushroll, inserting the flat end first.
Close the brushroll access door and press down until
both sides click into place.
s h a r kc l e a n . c o m
Advertisement
Table of Contents
