Advertisement
Section 2. Safety Advice
-
Please read this booklet thoroughly before installing and switching on the
appliance. The manufacturer accepts no responsibility for incorrect
installation and usage.
-
If this appliance is to replace an old refrigerator with a lock, as a safety
measure break or remove the lock and/or door before disposal.
-
Your old appliances contain insulation gases and refrigerant that must be
disposed of correctly. Please ensure that the refrigerant circuit is not
damaged before the appliance is taken away for correct disposal in line
with current legislation. If there is any doubt contact your Local Authority
for instructions.
-
This appliance may contain the refrigerant isobutene (R600a). This is a
natural gas with a high level of environmental compatibility; however,
caution is required as isobutene is a flammable gas. It is essential to ensure
that refrigerant tubes are not damaged during transportation and the
installation of the appliance. In the event that the refrigerant circuit is
damaged, avoid naked flames or sources of ignition and ventilate the room
in which the appliance is situated.
-
Do not damage the refrigerant circuit.
-
Do not allow children to play with the appliance. Children must never
play in or around the appliance.
-
If using an adaptor, this must be used in accordance with the
manufacturer's instructions and ensure that the electrical circuit is not
overloaded as this could cause overheating.
-
Do not twist or bend the cables, and keep them away from hot surfaces.
-
Do not plug ın or unplug this appliance with wet hands.
-
Following installation make sure that the power cable is not trapped
underneath the appliance.
-
If the power supply cord is damaged, it must be replaced by the
manufacturer, it's service agent or similarly qualified persons in order to
avoid a hazard.
9
Advertisement
