HP D5062 User Manual page 23

To access the Recall function, first select Information , then select Recall
from the sub-menu
WARNING
By pressing the
"Adjusting Your Monitor" on page 10 to adjust the monitor again).
Setting the Amount of Displayed Information
To set the amount of displayed information, change the screen resolution
of your computer. The higher the screen resolution, the more information
you can see on the screen. It is recommended that you use a resolution of
1024 x 768. It is recommended that you use a refresh rate of 60 Hz. The
image refresh rate is the number of times per second that the image is
redrawn.
NOTE LCD technology does not cause any flicker at low refresh rates.
Minimizing Energy Consumption
If your computer supports VESA monitor power management (available
on many HP computers), you can minimize the power consumed by the
monitor. There are two power saving modes:
• Suspend mode (uses less than 5W)
Sleep mode (uses less than 5W)
•
When the monitor enters power saving mode, the message
displayed for a few seconds before the screen blanks. In power saving
mode the front panel indicator light is amber.
To set these power saving modes, refer to the manual that came with your
computer.
Recall: If you press
settings will be recalled. The settings that are
affected by the Recall function are
•
Screen Geometry
• Horizontal Frequency
RECALL
EXIT
• Vertical Frequency
• Brightness / Contrast
button all previous adjustments are lost (refer to
HP L1510 15" LCD Monitor
Using Your Monitor
, factory preset
is
English
English 21