HP 2509p User Manual page 30

Operating the Monitor
Main Menu
Icon Options
Management
(continued)
Source Control
Information
Factory Reset
4–6 Features may vary by model.
Submenu Options Description (Continued)
DDC/CI Support Allows the computer to control some OSD menu features such
as brightness, contrast, and color temperature. Set to:
On
Off
The factory default is On.
Bezel Power LED Turns the light (LED) in the power button On and Off. When set
to Off, the light will remain off at all times.
Sleep Timer Provides the timer-adjustment menu options:
Set Current Time — Sets the current time in hours and minutes.
Set Sleep Time — Sets the time you want to place the monitor
in sleep mode.
Set on Time — Sets the time you want the monitor to wake up
from sleep mode.
Timer — Sets the Sleep Timer feature On or Off; the default
setting is Off.
Sleep Now — Immediately sets the monitor to enter
sleep mode.
Selects the default video input signal when the monitor is
connected to two active and valid video sources. The default is
DVI. You must restart the computer to have the change take
effect.
DVI Video input signal comes from DVI.
HDMI Video input signal comes from HDMI.
VGA Video input signal comes from VGA.
Default Source DVI
HDMI
VGA
The factory default is DVI.
Auto-Switch Source On
Off
The factory default is On.
Selects and displays important information about the monitor.
Current Settings Provides the current input video mode.
Recommended Settings Provides the recommended resolution mode and refresh rate
for the monitor.
Serial Number Reports the serial number of the monitor. The serial number is
needed if contacting HP technical support.
FW Version Reports the firmware version of the monitor.
Backlight Hours Reports the total hours of backlight operation.
Service Support For service support, go to: http://www.hp.com/support
Returns settings to factory defaults.
User's Guide