Checking The Brake And Clutch Fluid Levels - Yamaha FJR1300AW Owner's Manual

Table of Contents

Advertisement

PERIODIC MAINTENANCE AND MINOR REPAIR
Checking the brake and clutch
fluid levels
Front brake
1. Minimum level mark
6
Rear brake
1. Minimum level mark
EAU40270
Clutch
1. Minimum level mark
Insufficient brake fluid may allow air to
enter the brake or clutch systems, pos-
sibly causing them to become ineffec-
tive.
Before riding, check that the brake fluid
is above the minimum level mark and
replenish if necessary. A low brake fluid
level may indicate worn brake pads
and/or brake system leakage. If the
brake level is low, be sure to check the
brake pads for wear and the brake sys-
tem for leakage.
NOTE:
The rear brake fluid reservoir is located
behind panel C. (See page 6-6.)
Observe these precautions:
6-21
G
When checking the fluid level,
make sure that the top of the brake
or clutch fluid reservoir is level.
G
Use only the recommended quality
brake fluid, otherwise the rubber
seals may deteriorate, causing
leakage and poor braking or clutch
performance.
Recommended brake and clutch flu-
id:
DOT 4 brake fluid
G
Refill with the same type of brake
fluid. Mixing fluids may result in a
harmful chemical reaction and
lead to poor braking or clutch per-
formance.
G
The brake or clutch fluid reservoir
diaphragm will lose its shape from
the negative pressure if the fluid
level goes down too far. Be sure to
return the diaphragm to its original
shape before installing it into the
brake or clutch fluid reservoir.
G
Be careful that water or dust does
not enter the brake or clutch fluid
reservoir when refilling. Water will
significantly lower the boiling point

Advertisement

Table of Contents
loading

Table of Contents