Advertisement
5.1.5.
Line pressure should be increased to compensate for unusually long air hoses (over 8 metres). The minimum hose diameter should be
1/4" I.D. and fittings must have the same inside dimensions.
5.1.6.
Keep hose away from heat, oil and sharp edges. Check hose for wear, and make certain that all connections are secure.
5.2.
COUPLINGS
5.2.1.
Vibration may cause failure if a quick change coupling is connected directly to the wrench. To overcome this, connect a leader hose to
the wrench. A quick change coupling may then be used to connect the leader hose to the air line recoil hose. See fig1 & fig2.
fig.1
6. OPERATION
WARNING! Ensure you read, understand and apply safety instructions before use.
‰
6.1.
Only use impact sockets which are specifically designed for use with a impact wrench.
6.2.
Connect the wrench to the air hose as in chapter 3.
6.3.
Place the socket over the subject nut and depress the trigger to operate the wrench.
6.4.
To change direction push the button at the top of the handle. Direction of "R" for reverse and "F" for forward
6.5.
The flow of air may be regulated by adjusting flow valve at the base of the handle.
DO NOT use any additional force upon the wrench in order to remove a nut.
8
DO NOT allow wrench to free run for an extended period of time as this will shorten its life.
8
7. MAINTENANCE
WARNING! Disconnect the wrench from the air supply before changing accessories, servicing or performing any maintenance.
‰
7.1.
Replace or repair damaged parts. Use genuine parts only. Non-authorised parts may be dangerous and will invalidate the warranty.
7.2.
Lubricate the air wrench daily with a few drops of Sealey air tool oil dripped into the air inlet.
7.3.
Check and top up the gearbox by removing grub screw located on the side of the wrench.
7.4.
Clean the wrench after use.
DO NOT use worn or damaged sockets.
8
7.5.
Loss of power or erratic action may be due to the following:
a) Excessive drain on the air line. Moisture or restriction in the air pipe. Incorrect size or type of hose connectors.
To remedy check the air supply and follow instructions in section 4.
b) Grit or gum deposits in the wrench may also reduce performance. If your model has an air strainer (located in the area of the air
inlet), remove the strainer and clean it. Flush the wrench out with gum solvent oil or an equal mixture of SAE No 10 oil and paraffin.
Allow to dry before use.
7.6.
For a full service, contact your local Sealey service agent.
7.7.
When not in use, disconnect from the air supply, clean wrench and store it in a safe, dry, childproof location.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
01284 703534
sales@sealey.co.uk
Original Language Version
fig.2
,
www.sealey.co.uk
SA2/TS.V2
Issue 1
01/06/20
Advertisement
