Related Manuals for eTIGER ES-D1A
Summary of Contents for eTIGER ES-D1A
- Page 1 ES-D1A Wireless Motion Detector www.etiger.com Instrukcja pobrana ze sklepu www.ekocentrum24.pl...
- Page 2 Open the case and remove the battery activation strip to activate the batteries. Self-testing starts for 30 seconds. Images, illustrations and text are non-contractual. ETIGER and the ETIGER logo are registered trademarks and the property of ETIGER. Copyright © 2015 ETIGER. All rights reserved.
- Page 3 Installation Fix the bracket on the wall with screws and attach the detector to the bracket. Adjust the bracket to change the detection distance and angle. It is recommended to mount the detector 2m from the ground. Avoid mounting the detector close to windows, air conditioner, heater, refrigerator, oven, sunshine and places where the temperature changes fast or where the air stream flows frequently.
- Page 4 Mode Setting Testing mode Once the self-testing is complete, long press the test button. The sensor switches to testing mode, and scans once every 10 seconds. After 3 minutes, the LED blinks twice, and the sensor switches to working mode. Working mode / Stand-by mode In working mode, if the sensor is triggered more than twice within 3 minutes, it will switch to standby mode...
- Page 5 Specifications Power Supply: Housing material: DC 3V (AA 1.5V LR6 x2) ABS plastic Static current: Operating conditions: ≤90uA Temperature: - 10°C ~ +55°C Transmitting current: Relative Humidity: ≤80% ≤9.5mA (non-condensing) Transmission distance: Detector dimensions: ≤ 80 m (in open area) 107 x 53 x 32 mm Radio-frequency: Bracket dimensions:...
- Page 6 PCB Layout Jumpers for Zone setup Tamper switch LED working indicator Antenna Infrared sensor AA 1.5V LR6 Infrared sensor: Detects the infrared rays released by human body motion. Do not touch the surface. Keep the surface clean. Tamper switch: When the alarm system is armed, the tamper switch will trigger the alarm if the case is opened.
- Page 7 Standards This product bears the selective sorting symbol for waste electrical and electronic equipment (WEEE). This means that this product must be handled pursuant to European Directive 2002/96/EC in order to be recycled or dismantled to minimize its impact on the environment.
- Page 8 This user manual is available in other languages at www.etiger.com/eu/support ETIGER EUROPE Rue de la Loi, 25, 7100 La Louvière, Belgium service@etiger.com...
Need help?
Do you have a question about the ES-D1A and is the answer not in the manual?
Questions and answers