Camera Management; Camera Signal; Add/Edit Camera; Add Camera - TechVision PS8P2N8 Manual

8 channel 1u 4k

Table of Contents

Camera Management

Click StartSettingsCameraManage CameraCamera Signal to go to the interface as

shown below.

Some models may support analog signal switching to IP signal, which means decreasing (or

increasing) the number of analog channels, accordingly increasing (or decreasing) the number

of IP channels with the total channels unchanged.

The DVR device supports hybrid access of TVI, AHD, CVI and CVBS high definition cameras.

If the TVI high definition camera is accessed to the DVR, you should select TVI in the

following interface to show the camera image normally; if you select AHD, then there will be

no image or the image has no color. The default selection of the camera signal is Auto. If you

select Auto, the image of the camera will be shown normally regardless of the camera type.

Note: You can enable "Lite" in the interface if the DVR supports "Lite" recording. It will lower

the recording resolution and increase the recording frame rate. Please enable or disable the Lite

as you wish.

The network of the DVR should be set before adding IP camera (see 11.1.1 TCP/IP

Configuration for details).

Refer to the pictures below. Click Add Camera in the setup panel or

corner of the preview window to pop up the "Add Camera" window as shown below. You can

quickly add or add the IP camera manually.

4 Camera Management

DVR User Manual

in the top right

Table of Contents