Danby DDR70A3GDB Owner's Use And Care Manual page 11

INSTALLING PVC DRAIN HOSE
When using the continuous drain function, the PVC hose must be placed horizontally below the drainage hole. Avoid
uneven ground and folding the hose. NOTE: Should you damage or misplace the pvc drain hose, a standard garden
hose can be used.
CONTINUOUS DRAIN
The function of continuous drain can be performed using the following
steps:
1) To save having to periodically empty the water tank, this unit
can be confi gured for continuous drain. You can use the supplied
drain hose to connect to the continuous drain connector.
2) Unscrew and remove the drain cover at the rear of the unit (Fig. A).
3) Remove the soft rubber stopper, and place it in the water
tank for safe keeping (Fig. B).
4) Insert the drain hose through the hole of the drain cover (Fig. C).
5) Ensure the rubber seal ring is properly seated in the end of the
hose.
6) Connect the drain hose to the drain port (Fig. D).
7) Tighten the drain cover in clockwise direction onto the rear of the
unit (Fig. D).
8) Place the bucket in its original location (Fig. E).
OPERATING INSTRUCTIONS
8