Zanussi ZRA21600WA User Manual page 19

Problem
Water flows inside the refrigera-
tor.
Water flows on the floor.
Door is misaligned or interferes
with ventilation grill.
The temperature in the appliance
is too low/too high.
If the advice does not lead to the
desired result, call the nearest
brand-mark service.
Replacing the lamp
Disconnect the plug from the mains socket.
1. Remove the screw from the lamp cover.
2. Remove the lamp cover (refer to the
illustration).
www.zanussi.com
Possible cause
The door is not closed correct-
ly.
The water outlet is clogged.
Food products prevent that
water flows into the water col-
lector.
The melting water outlet is not
connected to the evaporative
tray above the compressor.
The appliance is not levelled.
The temperature regulator is
not set correctly.
The door is not closed correct-
ly.
The food products' tempera-
ture is too high.
Many food products are stored
at the same time.
The door has been opened of-
ten.
There is no cold air circulation
in the appliance.
3. Replace the used lamp with a new lamp of
4. Install the lamp cover.
5. Tighten the screw to the lamp cover.
6. Connect the plug to the mains socket.
7. Open the door.
Make sure that the light comes on.
Refer to "Closing the door".
Clean the water outlet.
Make sure that food products do
not touch the rear plate.
Attach the melting water outlet to
the evaporative tray.
Refer to "Levelling".
Set a higher/lower temperature.
Refer to "Closing the door".
Let the food products temperature
decrease to room temperature be-
fore storage.
Store less food products at the
same time.
Open the door only if necessary.
Make sure that there is cold air cir-
culation in the appliance.
the same power and specifically designed
for household appliances (the maximum
power is shown on the lamp cover).
Solution
19