Brother HL-L2357DW Online User's Manual page 227

Level 1 Level 2
WLAN WLAN Enable
Wi-Fi Push Button
Direct
PIN Code
Manual
Group Owner
Device Info.
Status Info.
I/F Enable
Network -
Reset
1 On connection to the network, if the machine's 'Boot Method' is 'Auto' the machine will attempt to set the IP address and Subnet Mask
from a boot server such as DHCP. If a boot server cannot be found, an APIPA IP address will be allocated, such as 169. 254. [001-254].
[000-255]. If the 'Boot Method' of the machine is set to 'Static' you must manually enter an IP address from the machine's control panel.
[Network] (HL-L2370DN)
Level 1 Level 2
TCP/IP Boot Method -
IP Address
Subnet Mask -
Gateway
Node Name
WINS Config -
WINS Server Primary
DNS Server
APIPA
IPv6
Ethernet -
Wired Status -
MAC Address -
Level 3 Level 4
- -
- -
- -
- -
- -
Device -
Name
SSID -
IP Address -
Status -
Signal -
Channel -
Speed
-
- -
- -
Level 3 Description
Choose the IP method that best suits your needs.
- Enter the IP address.
Enter the Subnet mask.
- Enter the Gateway address.
- Enter the Node name.
Select the WINS configuration mode.
Specify the IP address of the primary WINS server.
Secondary Specify the IP address of the secondary WINS server.
Primary Specify the IP address of the primary DNS server.
Secondary Specify the IP address of the secondary DNS server.
- Allocate the IP address from the link-local address range
automatically
- Enable or disable the IPv6 protocol.
- Choose the Ethernet link mode.
- Display the Ethernet link status.
- Display the MAC address of the machine.
Descriptions
Turn the wireless interface on or off.
Configure your Wi-Fi Direct network settings
using the one-button push method quickly.
Configure your Wi-Fi Direct network settings
using WPS with a PIN code quickly.
Configure your Wi-Fi Direct network settings
manually.
Set your machine as the Group Owner.
View your machine's device name.
Display the Group Owner's SSID.
Display your machine's IP Address.
Display the Wi-Fi Direct network status.
Display the current Wi-Fi Direct network signal
strength.
When your machine acts as Group Owner, the
LCD always displays Strong.
Display the channel in use when the Status is
G/O Active or Client Active.
Display the connection speed when the Status
is G/O Active or Client Active.
Enable or disable the Wi-Fi Direct connection.
Restore all network settings of your machine to
the factory settings.
1
.
223