Whirlpool GEQ9800PW Installation Instructions Manual page 9

27 in. (69 cm) electric dryer
Table of Contents

Advertisement

Available languages

Available languages

Optional exhaust installations
This dryer can be converted to exhaust out the right side, left side,
or through the bottom.
WARNING
Fire Hazard
Cover unused exhaust holes with one of the following
kits:
279818 (white)
279819 (almond)
279915 (graphite)
279925 (biscuit)
Contact your local dealer.
Failure to follow these instructions can result in death,
fire, electrical shock, or serious injury.
1
1. Standard rear offset exhaust installation
2. Left or right side exhaust installation
3. Bottom exhaust installation
Alternate installations for close clearances
Venting systems come in many varieties. Select the type best for
your installation. Two close-clearance installations are shown.
Refer to the manufacturer's instructions.
1
1. Over-The-Top installation (also available with one
offset elbow)
2. Periscope installation
2
2
NOTE: The following kits for close clearance alternate installations
are available for purchase. See the service numbers located in
your "Dryer User Instructions."
Over-The-Top Installation:
Part Number 4396028
Periscope Installation (For use with dryer vent to wall vent
mismatch):
Part Number 4396037 - 0 in. (0 cm) to 18 in. (45.72 cm)
mismatch
Part Number 4396011 - 18 in. (45.72 cm) to 29 in. (73.66 cm)
mismatch
Part Number 4396014 - 29 in. (73.66 cm) to 50 in. (127 cm)
mismatch
Special provisions for mobile home installations
The exhaust vent must be securely fastened to a noncombustible
portion of the mobile home structure. Do not use screws or other
fastening devices that extend into the interior of the vent to
secure vent.
Terminate the exhaust vent outside. The exhaust vent must not
terminate beneath the mobile home and must not be connected
to any other duct, vent or chimney.
Determine Vent Length
1. Select the route that will provide the straightest and most
3
direct path outdoors. Plan the installation to use the fewest
number of elbows and turns. When using elbows or making
turns, allow as much room as possible. Bend vent gradually to
avoid kinking. Avoid 90º turns.
9

Advertisement

Table of Contents
loading

Table of Contents