Table of Contents
Advertisement
Operating the product
C
If the Programme Selection knob is
turned when the Child Lock is active,
"Con" appears on the display. The
Child Lock does not allow any change
in the programmes and the selected
temperature, speed and auxiliary
functions.
C
Even if another programme is selected
with the Programme Selection knob
while the Child Lock is active, previously
selected programme will continue
running.
C
When the Child Lock is active and the
machine is running, you can switch
the machine to Pause mode without
deactivating the Child Lock by turning
the Programme Selection knob to
On / Off position. When you turn the
Programme Selection knob afterwards,
the programme will resu
To activate the Child Lock:
Press and hold 1st and 2nd Auxiliary Function
buttons for 3 seconds. The lights on the 1st
and 2nd Auxiliary Function buttons will flash
while you keep the buttons pressed for 3
seconds.
To deactivate the Child Lock:
Press and hold 1st and 2nd auxiliary function
buttons for 3 seconds while any programme is
running. The lights on the 1st and 2nd Auxiliary
Function buttons will flash while you keep the
buttons pressed for 3 seconds.
C
In addition to the method above, to
deactivate the Child Lock, switch the
Programme Selection knob to On / Off
position when no programme is running,
and select another programme.
C
When the power is restored after a
power failure or after your machine is
unplugged and plugged in again, the
Child Lock will not be deactivated when
the machine resumes operating.
5.13 Progress of programme
Progress of a running programme can be
followed from the Programme Follow-up
indicator. At the beginning of every programme
step, the relevant indicator light will turn on
Washing Machine / User's Manual
and light of the completed step will turn off.
You can change the auxiliary functions, speed
and temperature settings without stopping
the programme flow while the programme
is running. To do this, the change you are
going to make must be in a step after the
running programme step. If the change is
not compatible, relevant lights will flash for 3
times.
C
If the machine does not pass to the
spinning step, Rinse Hold function might
be active or the automatic unbalanced
load detection system might be activated
due to the unbalanced distribution of the
laundry in the machine.
5.14 Loading door lock
There is a locking system on the loading door of
the machine that prevents opening of the door
in cases when the water level is unsuitable.
Loading door light will start flashing when the
machine is switched to Pause mode. Machine
checks the level of the water inside. If the
level is suitable, Loading Door light illuminates
steadily within 1-2 minutes and the loading
door can be opened.
If the level is unsuitable, Loading Door light
turns off and the loading door cannot be
opened. If you are obliged to open the Loading
Door while the Loading Door light is off, you
have to cancel the current programme; see
"Cancelling the programme".
5.15 Changing the selections after
programme has started
Switching the machine to pause mode
Press the Start / Pause button to switch the
machine to pause mode while a programme
is running. The light of the step which the
machine is in starts flashing in the Programme
Follow-up indicator to show that the machine
has been switched to the pause mode.
Also, when the loading door is ready to be
opened, Loading Door light will also illuminate
continuously in addition to the programme
step light.
27 / EN
Advertisement
Table of Contents
