Subscribe to Our Youtube Channel
Related Manuals for Matrix CHF611
Summary of Contents for Matrix CHF611
- Page 1 Manual for installation, use and maintenance CHF611 Extractor year parts 1 year labour guarantee www.matrixappliances.co.uk...
-
Page 2: Table Of Contents
Contents: Important Using your extractor Care and maintenance Changing the light bulbs Electrical Information Troubleshooting Mains electricity connection Mounting your extractor Cleaning guide Troubleshooting 17 - 20 Installation Installation - preparation How to install the hob Mains electrical connection Energy efficiency information IMPORTANT: Please read the user instructions carefully before using the appliance for the first time and before installing it. -
Page 3: Important
Important The CDA Group Ltd cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note that CDA reserve the right to invalidate the guarantee supplied with this product following incorrect installation or misuse of the appliance or use in a commercial environment. - Page 4 Parts intended to come into contact with food conform to 1935/2004/ IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH EU DIRECTIVE 2012/19/EU. At the end of its working life, the product must be taken to a special local authority waste collection centre or to a dealer providing appliance recycling services.
-
Page 5: Using Your Extractor
• The performance of your extractor will vary depending on a number of factors. These include: type of extraction, length of ducting, room volume, ventilation available and cleanliness of the filters. Using your extractor For best performance, you should switch on the extractor 15 minutes before starting to cook and leave it to run for approximately 15 minutes after the end of cooking. -
Page 6: Care And Maintenance
Care and maintenance IMPORTANT : DO NOT PERFORM MAINTENANCE OR CLEANING OF THE EXTRACTOR WITHOUT FIRST SWITCHING OFF THE ELECTRICITY SUPPLY. Cleaning You should use a nonabrasive cleaner. Any abrasive cleaner (including Cif) will scratch the surface and could erase the control panel markings. - Page 7 Please note: Cleaning the grease filter in the dishwasher may lead to discolouration. This is normal and does not constitute a fault with the appliance. Changing the charcoal filter (re-circulating only) To ensure best performance of your extractor, you should replace the charcoal filter every four to six months, depending on use.
-
Page 8: Electrical Information
The light is designed for use during cooking and not for general room illumination. Extended use of the light can reduce the life span of the bulb. Bulb replacement is not covered by the guarantee. Only use bulbs recommended for your extractor. Do not fit bulbs of a higher power rating. -
Page 9: Mains Electricity Connection
Mains electricity connection THIS APPLIANCE MUST BE CONNECTED TO THE MAINS SUPPLY BY A COMPETENT PERSON, USING FIXED WIRING VIA A DOUBLE POLE SWITCHED FUSE SPUR OUTLET AND PROTECTED BY A 3A FUSE. Warning! This appliance must be earthed The appliance should be connected by a qualified electrician, who is a member of the N.I.C.E.I.C. - Page 10 When installing this product we recommend you seek the help of another individual. Do not mount the isolation switch behind the chimney section. It is a requirement that you must be able to isolate the extractor from the mains electrical supply after installation. This appliance is intended to be connected to the mains electrical supply by means of an isolation switch and fused spur and is intended to be protected by a 3A fuse.
-
Page 11: Mounting Your Extractor
RIDDOR (The height should be measured from the top of the burners). Below is a guide to accompany Fig. 4 CHF611 A 60.5 120.5 340-380 175 * The actual height of C depends on the height of the ceiling and the... - Page 12 IN THE ABSENCE OF ANY INSTRUCTIONS SUPPLIED WITH THE GAS HOB, THE MINIMUM DISTANCE BETWEEN THE HOB AND EXTRACTOR MUST BE AT LEAST 760mm. The width of any hob must not be greater than the width of the extractor installed above it. Ducting and ventilation For best performance and lowest noise output, we recommend the use of 125mm ducting.
- Page 13 Installation steps Figu re 2 - M ar k wal l as req ui red (see ta bl e 1) Tools required Mark wall as required (see table 2) Fig. 6 Fig. 7 Drill holes Drill holes Fit wall fixings and top screws - Figu re 3 - D rill h oles Ensure that any fixings you use are appropriate for the wall type.
- Page 14 Figu re 7 - Mo unt chimne y bracke ts Mount chimney brackets Fix ducting (seal joint) Fix ducting (seal joint) Figu re 8 - Fix ducting (s ea l joint) Figu re 7 - Mo unt chimne y bracke ts Figu re 8 - Fix ducting (s ea l joint) Figu re 10 - Adj ust an d s ecure the chim ne y Fig.
-
Page 15: Energy Efficiency Information
Energy Efficiency Information Attribute Symbol Value Units Model Identification CHF611SS Annual Energy Consumption 94.0 Hood Time increase factor 11.5 Hood 97.4 Hood 220.9 Point Point Maximum airflow 382.3 Measured electric power at Best 91.8 Nominal lighting power 56.0 Average illumination of the lighting Middle system on the cooking surface Measured power consumption in... - Page 16 Serviced by For our Customer Care Department, or for Service, please contact us on: The CDA Group Ltd. Harby Road, Langar, Nottinghamshire, NG13 9HY Tel: 01949 862012 Fax: 01949 862003 Email: customer.care@cda.eu...
Need help?
Do you have a question about the CHF611 and is the answer not in the manual?
Questions and answers