JVC KD-R736BT Instructions Manual page 21

Menu item
FADER *3*4
BALANCE *4
LOUD
(Loudness)
VOL ADJUST
(Volume adjust)
SUB. W
(Subwoofer)
SUB.W LPF *5
(Subwoofer low-
pass filter)
SUB.W LEVEL *5
(Subwoofer level)
HPF *5
(High-pass filter)
BEEP
(Keytouch tone)
AMP GAIN *6
(Amplifier gain)
SSM
MONO
(Monaural mode)
IF BAND
(Intermediate
frequency band)
RADIO TIMER
*3 If you are using a two-speaker system, set the fader level to "00".
*4 This adjustment will not affect the subwoofer output.
*5 Displayed only when <SUB.W> is set to <ON>.
*6 The volume level automatically changes to "VOLUME 30" if you change to <LOW POWER>
with the volume level set to higher than "VOLUME 30".
Selectable setting (Initial: [XX])
R06 — F06 [00]: Adjusts the front and rear speaker output balance.
L06 — R06 [00]: Adjusts the left and right speaker output balance.
ON: Boosts low and high frequencies to produce a well-balanced sound at
a low volume level.
[OFF]: Cancels.
-05 — +05 [00]: Presets the volume adjustment level of each source,
compared to the FM volume level. Before adjustment, select the source you
want to adjust. ("VOL ADJ FIX" appears if "FM" is selected.)
OFF: Cancels.
[ON]: Turns on the subwoofer output.
LOW 55Hz/MID 85Hz/[HIGH 120Hz]: Audio signals with frequencies
lower than 55 Hz/85 Hz/120 Hz are sent to the subwoofer.
00 — 08 [08]: Adjusts the subwoofer output level.
LOW 100Hz/MID 120Hz/HIGH 150Hz: Activates the High Pass Filter.
Audio signal with frequencies lower than 100 Hz/120 Hz/150 Hz are cut off
from the front/rear speakers.
[OFF]: Deactivates. (All signals are sent to the front/rear speakers.)
[ON]/OFF: Activates or deactivates the keypress tone.
LOW POWER: VOLUME 00 — VOLUME 30 (Select if the maximum power of
each speaker is less than 50 W to prevent damaging the speakers.)
[HIGH POWER]: VOLUME 00 — VOLUME 50
For settings, page 6. (Displayed only when the source is "FM".)
Displayed only when the source is "FM".
[OFF]: Enables stereo FM reception.
ON: Improves the FM reception but stereo effect will be lost.
[AUTO]: Increases the tuner selectivity to reduce interference noises
between adjacent stations. (Stereo effect may be lost.)
WIDE: Subject to interference noises from adjacent stations, but sound
quality will not be degraded and the stereo effect will remain.
For settings, page 7.
Menu operations
ENGLISH | 21