Operation; Wall Mount Installation; Exploded View - Stanley ST-24W Instruction Manual

24" Wall Mount Fan
24W
24WOSC
!
WARNING: The installer MUST be certain that the
support bracket is mounted to a minimum of a
2x4" stud, and that it is able to support 50 pounds
continuously.
NOTICE: The bolts and screws are mix of metric and
standard.

Exploded View

Lower Supporter
Bend Pipe
Wall Mount
Spring Gasket
Motor Rear Guard
M12 Nut

OPERATION

Wall Mount Installation

Tools Needed:
• Phillips screwdriver
• Adjustable wrench (included in accessory bag)
1. Secure the wall mount to the desired location with
appropriate hardware (not provided).
2.
Attach the bend pipe to the wall mount with the provided
bolts. Tighten the bolts.
3.
Loosen the Phillips head set screw on the lower supporter.
Attach the motor to the bend pipe by using the M12x40
screw, nut, and washer to connect the lower supporter to
the upper supporter. Tighten the M12x40 screw and the
Phillips head set screw. Ensure the screws are tight.
4.
Remove the four (4) M6x10 Phillips head flange screws
from the motor.
5. Attach the rear guard to the motor with the four (4)
M6x10 Phillips head flange screws.
6.
Attach the blade to the motor shaft by using the hex
wrench (in accessory bag). Make sure the hex set screw is
facing toward the motor (hub down) when attaching.
7.
Attach the front guard to the rear guard, using the snap
joint to tighten.
Blade
M12x40 Screw Upper Supporter
Set Screw
Front Guard
M6x10 Flange Screw
ENGLISH
3