Retrofit An Existing Home - Hide-A-Hose HPHS5000W Installation Manual

Retrofit an Existing Home

Use the mud cover as a template
Push the bottom two pointed
tabs into the sheetrock. The top
pointed tab can be bent down
as you pull the top of the frame
into the hole. The tabs will help
hold the frame in place while you
install the valve. You may need to
push a couple of small finish nails,
horizontally into the sheetrock,
through the holes located on the
side of the frame.
Installation of pipe runs and trim
can follow same instructions as for
new construction.
- 10 -
to cut the hole.
Finish
To allow the frame to fit through
the valve hole in the sheetrock,
cut approximately 3/4" (1.9 cm)
off the forks.
You will need to score and cut
off both of the mounting tabs in
order for the rough-in frame to fit
in the hole.
Insert the Rough-in frame
horizontally. Then turn it back
upright behind the wall.
nail
Pointed
tabs
HS5000 INSTALLATION GUIDE
Finish
nail