Dvd Setup; Hdstb Setup; Monitor Out Setup - Zenith Z56DC1D Installation And Operating Manual, Warranty

Hide thumbs Also See for Z56DC1D:
Table of Contents

Advertisement

DVD Setup

DVD Setup
How to connect
1. Connect the DVD video outputs (Y, P
NENT (Y, P
, P
) INPUT jacks on the TV and connect the
B
R
DVD audio outputs to the AUDIO INPUT jacks on the TV, as
shown in the figure.
2. If your DVD only has an S-Video output jack, connect this to
the S-VIDEO input on the TV and connect the DVD audio out-
puts to the AUDIO INPUT jacks on the TV, as shown in the fig-
ure.
Note: If your DVD player does not have component video output,
use S-Video.
How to use
1. Turn on the DVD player, insert a DVD.
2. Use the TV/VIDEO button on the Remote Control to select
Component 1 or Component 2. (If connected to S-VIDEO,
select the Video2 or Front Video external input source.)
3. Refer to the DVD player's manual for operating instructions.
• Component Input ports
To get better picture quality, connect a DVD player to the
component input ports as shown below.
Component ports
on the TV
Video output ports
on DVD player

HDSTB Setup

HDSTB Setup
- This TV can receive Digital Over-the-air/Cable signals without an external digital set-top box. However, if you do receive Digital
signals from a digital set-top box or other digital external device, refer to the figure as shown below.
- This TV supports HDCP (High-bandwidth Digital Contents Protection) protocol for Digital Contents (480p,720p,1080i).
How to connect
Use the TV's COMPONENT (Y, P
HDMI2 jack for video connections, depending on your set-top box connec-
tor. Then, make the corresponding audio connections.
Note: HDMI(High Definition Multimedia Interface): Input that accepts uncom-
pressed digital signal and multi channel digital audio signal.
How to use
1. Turn on the digital set-top box. (Refer to the owner's manual for the digital
set-top box.)
2. Use TV/VIDEO on the Remote Control to select Component 1,
Component 2, RGB-DTV, HDMI1/DVI or HDMI2 source.
, P
) to the COMPO-
B
R
P
Y
P
B
R
Notes:
Pr
Y
Pb
• Digital Audio will not work for Component 1 input source.
Y
B-Y
R-Y
• Digital Audio operation has priority if Digital Audio and AUDIO L/R
Cr
Y
Cb
P
Y
P
R
B
, P
) INPUT, RGB, HDMI1/DVI or
B
R
DIGITAL AUDIO
OPTICAL OUTPUT
DIGITAL AUDIO
OPTICAL INPUT
(COMPONENT2)
DIGITAL AUDIO
OPTICAL INPUT
(DVI)
H
/
D
D
M
V
I
I
1
H
D
M
I
2
UPGRADE
PORT
(R) AUDIO (L)
B
R
are connected at the same time.
Signal
Component 1/2
480i
480p
720p
1080i
ANTENNA
RGB INPUT
CABLE
PC/DTV
S-VIDEO
(XGA/
480p/
720p/
COMPONENT
1080i)
INPUT2
INPUT1
MONITOR
INPUT2
RGB/DVI INPUT
OUT
Y
(L)
AUDIO
P
B
(R)
MONO
P
R
VARIABLE
AUDIO OUT
(L)
(L)
AUDIO
AUDIO
(R)
(R)
DTV/DVD INPUT
or
DIGITAL AUDIO
S-VIDEO
OPTICAL
DVD
RGB-DTV,HDMI1/DVI,HDMI2
Yes
No
Yes
Yes
Yes
Yes
Yes
Yes
Owner's Manual 13
Installation
INPUT1
VIDEO
(L)
AUDIO
(R)
(R) AUDIO (L)

Advertisement

Table of Contents
loading

This manual is also suitable for:

Z62dc1d56dc1duc

Table of Contents