Before Using For The First Time; Disposal Information - Bosch BSG72225 Instructions For Use Manual

en
cleaner if it is blocked and overheating.
Unplug the power cord from the mains and
make sure that the nozzle, suction pipe
and hose are not blocked. Also check
whether the filter needs changing.
Having cleared the blockage, leave the
vacuum cleaner to cool down for at least
one hour. It can then be switched back on
again.

Disposal information

Packaging
The packaging is designed to protect the
vacuum cleaner from being damaged
during transportation.
It is made of environmentally-friendly
materials and can be recycled.
Dispose of packaging that is no longer
required at an appropriate recycling point.
Used vacuum cleaners
Used vacuum cleaners still contain many
recyclable materials.
Therefore, please take used vacuum
cleaners/used exhaust filter change
indicators to your retailer or recycling
centre so that they can be recycled. For
current disposal methods, please enquire
at your appliance dealership or local
council.
Please note
!
The mains socket must be protected by a
16 amp fuse minimum.
If a circuit breaker should trip when you
switch on the vacuum cleaner, this may be
because other electrical appliances which
have a high current draw are connected to
the same power circuit.
To prevent the fuse from tripping, select
the lowest power setting before switching
the vacuum cleaner on, and increase the
power only once it is running.
Fold out picture pages.

Before using for the first time

1*
Figure
Push the handle onto the flexible hose until
it engages.
Setting up
2
Figure
a) Push the flexible hose adapter into the
opening on the vacuum cleaner until it
engages.
b To remove the flexible hose, press the
release button and pull the hose out.
3*
Figure
a) Connect the handle and the telescopic
tube together.
b) Push the handle into the telescopic tube
until it engages.
To release the connection, squeeze the
locking collar and pull the telescopic tube
out.
4*
Figure
a) Connect the floor tool and the telescopic
tube together.
b) Push the telescopic tube straight into the
connecting piece of the floor tool until it
engages.
To release the connection, squeeze the
locking collar and pull the telescopic tube
out.
5*
Figure
To adjust the length of the telescopic tube,
adjust the adjusting sleeve/sliding switch
in the direction of the arrow and adjust the
tube to the required length.
13